Industrial Floor Repairs

Service Details:

Our Industrial Floor Repairs services is suitable for demanding high traffic distribution centers as well as moderate duty commercial and retail buildings. This includes concrete and screed overlays and in addition to this, crack and joints are also filled in the concrete slab. As it is believe that even a small crack or surface defect can create a hazardous situation in locations where forklifts frequently operate. Our floor repairing solutions have long lasting effect with minimal interference to the work environment

Advantages:

• Concrete floor slab renovation
• Repair and stabilization of floor joints
• Repairing of crack and potholes
• Rectification of damage from forklifts
• Use of non toxic fillers
• Fast setting patch repairs
• Hygienic coatings for the food industry
• Abrasion, chemical and slip resistant

Service Details:

Joint Repairing Mortar - Avcrete HSRM is a high strength repair mortar which is ideal for vertical and overhead repairs. It is basically a general purpose cementitious, hand applied, patch repair mortar with excellent anti-sag properties for overhead applications. It is ideal for repairs to sections upto 50 mm.

Advantages:

• Polymer modified
• Excellent volume stability
• High built
• Low permeability
• Compensated shrinkage
• Excellent bonding
• Long term durability

Technical description:

• Can accommodate: Depths to 50 mm vertically, 20 mm overhead and 10- 100 mm horizontally

Recommended applications:

• Reinstatement mortar for general patch repairs to concrete structures

Surface preparation:

• Utmost care should be taken to remove all loose concrete, laitance, grease, paint and oil through the approved method of grit blasting and needle gun

Curing:

• Immediately after the completion of troweling, mist spraying with water is required for curing Avcrete- HSRM
• In case of fast drying conditions, covering with hessian cloth may be required for supplementary protection

Exposed steel reinforcement:

• The steel reinforcement bars are subjected to grit blast process for removing all active rusting
• If mechanical brush or grinder is applied then utmost attention should be paid to the rear of bars

Warning:

• Substrate or air temperature should be maintained between 5 C and 35 C for repairing work
• For any application above 35, manufacturer should be consulted for instructions

Physical properties: