Curing Compound

Service Details:

The application  Commercial Curing Compound need particular time to dry once the place is dry it is ready for use, drying time is approximately two hours, differs from place to place depending on the amount of air humid, heat and temperature. 

Features:
• Increases light reflectance 
• Stops the pre-mature water loss from freshly laid concrete 
• Reliable 

Service Details:

Curing Compound - Avcure Acry is widely recognized as the floor resurfacer for heavy duty industries. It is developed specifically for use as conductive flooring. This flooring generally comprises of cement, graded high strength aggregates and performance polymers. In order to get an anti- static floor, this is applied in just 12 to 40mm of thickness onto new or existing base concrete surface.This flooring generally comprises of cement, graded high strength aggregates and performance polymers. In order to get an anti- static floor, this is applied in just 12 to 40mm of thickness onto new or existing base concrete surface.

Surface preparation:

• Utmost care should be taken to remove all loose concrete, laitance, grease, paint and oil through the approved method of grit blasting and needle gun

Curing:

• Immediately after the completion of troweling, mist spraying with water is required for curing Avcrete- HSRM
• In case of fast drying conditions, covering with hessian cloth may be required for supplementary protection
• Exposed steel reinforcement:
• The steel reinforcement bars are subjected to grit blast process for removing all active rusting
• If mechanical brush or grinder is applied then utmost attention should be paid to the rear of bars

Warning:

• Substrate or air temperature should be maintained between 5 C and 35 C for repairing work
• For any application above 35, manufacturer should be consulted for instructions

Cleaning:

• Avcrete- HSRM should be immediately removed from tools and equipment by using clean water
• It can be removed by acid etching or by other mechanical means

Priming:

• Prior to the priming, remove all dust by vacuum or brush
• Thoroughly damp the concrete or masonry surface with water
• Before priming, remove any standing water
• All the components should be mixed and scrub well into substrate as per the instructions
• Avcrete- HSRM is then applied to the primer
• The primer must not be allowed to dry out

Physical properties: